The RAM Dehumidifier allows you to program a predefined humidity levels which the unit will then maintain, so you can rest assure your growing space is maintaining the perfect temperature. Humidity is often overlooked by growers but avoiding damp, humid conditions especially during flowering can completely avoid major problems such as powdery mildew, mould, pest attacks, poor plant health. Using a Dehumidifier can transform your growing environment with the click of a button.
With a simply easy to use electronic display the Ram 10L Dehumidifier features:
- -Simple Plug-N-Play setup
- -Provides precise environment control over humidity
- -Removes up to 10L a day
- -Protects your plants from powder mildew and damp issues
- -Continuous drainage option
- -Improvement health, growth and development
- -Increase in the weight and quality of your yields
- -Weight (tank empty): 10Kg
- -Working temperature: 5ºC to 32ºC
- -Noise level: 42dB
- -Treated air rate: 100m3/hour
- -Working space: 10m2 to 20m2
- -Maximum dehumidifying capacity: 10 Litres/day (at >80%RH and >30ºC)
- -Power consumption: 200 Watts
The Ram Dehumidifier is easy to use, please note the following- The dehumidifier should be placed at least 20cm (8 inches) away from any walls or surfaces to allow free movement of air around it.
If you wish to run the condensed water straight to a drain (bypassing the tank) then the supplied drainage pipe needs to be connected. To do this, pull out the drainage tank at the rear, locate the condenser outlet at the top-right inside of the tank cavity. Push one end of the supplied pipe firmly over the outlet and close the tank running the pipe through the notch on the rear. The other end of the pipe can then be run to a drain.
The control panel is simple to use. Press the power button to bring the unit out of standby. The power indicator light will show green and the 2-digit display shows the current relative humidity.
Use the "Setting" button to set the RH that you wish to get down to. successive presses will cycle through the options: 35% > 40% > 45% > 50% > 55% > 60% > 65% > 70% > 75% > 80% > CO (continuous operation regardless of what the RH has been reduced down to). If the button is not pressed for 5 seconds, the desired RH will be set, and the display will go back to showing the current RH. If the setting button is pressed and held for 3 seconds the unit will display the current temperature in ºC.
To set a length of time for the unit to run for before going into standby, press the "Timer" button. Each press will increase the number of on-hours by 1 as shown on the display. After a few seconds the display will return to showing the current RH. When the timer function is operating the timer indicator light will show green.
The unit can be set to operate in "Dry" mode or "Quiet" mode. For maximum dehumidification speed the unit should be left in "Dry" mode. In this mode the "Dry" indicator light will show red. To reduce the sound of the fan, press the "Mode button". The fan speed (and noise) will be reduced and the "Quiet" indicator light will show green. However, in this mode the rate of dehumidification will also be reduced.